The LilyPad Arduino Simple Board is a small sewable computer. It can be stitched to fabric and connected to other electronic pieces with conductive thread. This LilyPad board has 11 pins — the silver petal-like tabs that ring the outside of the board. Each of these pins, with the exception of (+) and (-), can control an attached input or output device (like a light, motor, or switch). This board is based on the ATmega328V microcontroller. The microcontroller is the black square in the center of the board (top view). You can program this LilyPad board using the Arduino programming environment. See the LilyPad Arduino getting started guide for instructions on setting up your board and writing programs. See the LilyPad Arduino E-Sewing tutorial for instructions on attaching your board to fabric.
Note: we now recommend using the LilyPad Arduino SimpleSnap for most projects. It includes an integrated battery and snap connectors.
This board has 11 pins (9 IO pins plus power (+) and ground (-) pins), an on-off switch, and a built in battery socket. A Li-Po battery plugged into the socket will charge whenever the board is attached to a computer. An orange charging light will glow while the battery is charging and turn off when charging is complete.
|digital IO pins||9|
|analog input pins||4|
|power||board requires 2.7-5.5 Volts|
|plug a 3.7V LiPo battery into the built in socket|
50mm outer diameter
Thin 0.8mm PCB
How to Attach
Sew this board to your project using conductive thread. Stitch from tabs on the LilyPad board to tabs on the components. Make sure to make tight connections between your thread and the board by stitching through each tab at least three times.
For detailed sewing instructions see the LilyPad Arduino E-Sewing tutorial.
Unplug the battery before washing. Hand wash in cold water with a gentle detergent. Do not dry clean.